6/26/2023 0 Comments Unistall zadig driver![]() While on some Windows systems this behavior sometimes seems to happen accidentally, there are cases where it is explicit wanted behavior, to assign a specific USB driver other than the SEGGER one to J-Link.įor example, this is the case when using OpenOCD which uses WinUSB to communicate with J-Link and therefore needs the WinUSB driver to take control over the J-Link probe, while by default the SEGGER USB driver takes over control. In this step, select Xin-Mo Programmer and remember the Vendor ID & Product ID on a paper. Run inf-wizard.exe, according tips to generate drivers. ![]() Follow the screenshots below to assign the SEGGER USB driver to take control over the J-Link probe plugged, the win10 will install drivers automatically.Locate the J-Link USB device that has just been added when J-Link was connected.It seems that you can change which driver is loaded depending on the USB port used. Note that if you insert the dongle into a different USB port you may have to use Zadig again. Before you proceed make sure the USBID matches the VID/PID. ![]() Make sure that the J-Link software package, including the USB drivers are installed The big button underneath will say Replace Driver or Reinstall Driver.When using those drivers, J-Link will successfully enumerate and show up as "J-Link" in the Windows Device Manager but using the J-Link with the J-Link software package and other software that relies on this package is impossible. There are some third party J-Link drivers available, which cannot be used with the J-Link software.
0 Comments
Leave a Reply. |